08-16-2017, 10:28 AM
Hello,
I have a QNAP TS-1079 Pro NAS server with 10x TB hard disks (Seagate ST4000VN008).
On the NAS are 2 drives / volumes, each with 5 HDD's in RAID6. For each drive, there is a Windows share (SMB 2.0).
If I now connect a share on a Windows Server 2016 for example and try to copy a 3GB file on it, the process is stoping after a view seconds. After that both shares a not longer availabe and accessable from the windows server. But the QNAP GUI works very well.
For testing propose Ihave setup the shares via iSCSI & FTP but same issue herer.
The latest firmware version (4.2.1) is installed on the QNAP. 2 weeks ago, the NAS was already set to factory settings back to eliminate errors in the configuration. But nothing helps.
Any helps with this issue?
I have a QNAP TS-1079 Pro NAS server with 10x TB hard disks (Seagate ST4000VN008).
On the NAS are 2 drives / volumes, each with 5 HDD's in RAID6. For each drive, there is a Windows share (SMB 2.0).
If I now connect a share on a Windows Server 2016 for example and try to copy a 3GB file on it, the process is stoping after a view seconds. After that both shares a not longer availabe and accessable from the windows server. But the QNAP GUI works very well.
For testing propose Ihave setup the shares via iSCSI & FTP but same issue herer.
The latest firmware version (4.2.1) is installed on the QNAP. 2 weeks ago, the NAS was already set to factory settings back to eliminate errors in the configuration. But nothing helps.
Any helps with this issue?