A. Product overview
Reaction kettle water cooled chiller is mainly applied to the reaction kettle jacketed type or snake pipe reactor, this machine can use cold water, according to the volume of the reaction kettle, model selection of the specific heat and cooling time is calculated in specific gravity, reactor cooling, cold water machine set to be lower than the material target temperature over 10 degrees.
B. Parameters of the product
Reaction kettle water cooled chillerSJ-40WF
Freezing capabilitykcal/hr(50Hz)113520
Power sourceV3鈭?380锝?80V- 50HZ
Electric currentA59
RefrigerantKindR407C/R404A
FILLING QUANTIT锛坘g锛?/p>20
Power of compressorKW26.4
Quantity of compressor
4
Cooling water volumem3/h32
Power of water pumpKW4
Refrigerated water flowm3/hr23
Diameter of freezing water pipeMM80
Overall dimensionL锛坢m锛?/p>2400
W锛坢m锛?/p>1000
H锛坢m锛?/p>1650
Weight of machinekg910
C. Product details
Explosion-proof chiller production process:
Explosion-proof chillers are mainly used in chemical, reactor, gas manufacturing, pharmaceutical, coal mines and other inflammable and explosive places. In order to meet the requirements of explosion-proof standard chillers in the production process, all electrical appliances must require explosion-proof certificates, electrical appliances and explosion-proof boxes. Connections require an explosion-proof connection to the wound hose.
The water system of the water-cooled chiller in the reaction kettle is made of stainless steel to ensure the cleanliness of the water system.The remote control of the chiller can be connected to the main control program of the reactor, realizing automatic control.
Notes:
1. When the water-cooled chiller of the reaction kettle is used in combination, it is necessary to pay attention to the height of the cooling water inlet and outlet of the kettle. If it is higher than the cooling water inlet and outlet of the chiller of the selected model, a check solenoid valve shall be installed.
2. If the reactor has a large volume, a heat preservation tank with a larger capacity should be added to the outside of the chiller. Pay attention to installing valves in the inlet and outlet positions of the tank and the reactor, so as to retain the cooling in the tank when cleaning the reactor.
3. When the setting temperature is higher than 0, groundwater is not allowed to be used for cooling water. Please keep the refill valve normally open when using tap water.
D. FAQ
Q: When the material in the reactor needs to be cooled to 0, what is the temperature of the cooling water?
A: Hello!Because the reaction kettle is mainly divided into jacketed type and serpentine coil type, these two ways in thermal efficiency are relatively poor, so the temperature difference between cooling water and material needs to reach 10 degrees or greater, can be set to 15 degrees or so commonly, or cold water machine the temperature sensor temperature testing point for materials (testing materials, when the temperature setting material target) in addition, the cooling water use glycol solution or other type of low temperature medium.Bulk Water Cooled Chiller
website:http://www.asj-aircooler.com/water-cooled-chiller/